Abs Error; Abs Deactivated - BMW S 1000 RR Rider's Manual

Activating suppression of the
fault message in the
mode.
Motorcycle has fallen over
! VDS
(Vertical Down Sensor) is
shown in the empty display.
Possible cause:
The fall sensor has detected a
fall and switched off the engine.
Position motorcycle upright
Switch ignition off and then on
again or switch emergency ON/
OFF switch on and then off
again.
Fall sensor defective
! VDS
(Vertical Down Sensor) is
shown.
Possible cause:
A defect was determined in the
fall sensor.
Contact a specialized work-
shop, preferably an authorized
BMW Motorrad retailer.
ABS self-diagnosis not
SETUP
completed
with BMW Motorrad Race
OE
ABS
ABS warning lamp flashes.
Possible cause:
The ABS function is not avail-
able, because the self-diagno-
sis has not been completed. To
check the wheel sensors, the
motorcycle must be driven a few
yards.
Ride off slowly. It must be
noted that the ABS function
is not available until the self-
diagnosis has been completed.

ABS deactivated

with BMW Motorrad Race
ABS OE
ABS warning lamp lights
up.
Possible cause:
The ABS system has been deac-
tivated by the driver.
Switch on ABS function
( 42).

ABS error

with BMW Motorrad Race
OE
ABS
ABS warning lamp lights
up.
Possible cause:
The ABS control unit has de-
tected an error. The ABS func-
tion is not available.
Continued driving is possible
while taking the failed ABS
function into account. Observe
additional information on situa-
tions which can lead to an ABS
error ( 101).
3
29
z