Turning The System All On - Bosch 2212 User Manual

Turning the System All On

Use this function to turn on the entire system. Once you've pressed [9],
exit delay time starts to count down. The length of exit delay time is
programmed by your security company. Check with them to learn how
much exit delay time your system allows. In this example, exit delay is
30 seconds. You should leave before the exit delay time expires. Leaving
after exit delay expires causes an alarm event.
1. Make sure all points are normal (not faulted).
2. Press [9]. If all points are normal, exit delay time begins. You
should leave now. If your system has a faulted point, you should
return it to normal, or refer to Bypass Points.
30 SEC TO EXIT!
During exit delay, you may stop the system from turning on by
pressing [CLEAR]:
TO STOP
PRESS CLEAR
If you wish to, you can turn the system All On with No Delay by
pressing [9] again:
FOR NO DELAY
PRESS 9
If you wish to, you may bypass points by pressing [
system prompts you through the procedure:
TO BYPASS POINTS
PRESS
3. When exit delay time expires, the keypad beeps three times and
the system turns on.
ALL ON
SYSTEM OK
4. To turn the system off, enter your personal passcode.
]. The
11