Turning The System All On - Bosch D220 User Manual

Turning the System All On

Use this function to turn on the entire system. Once you press the [9]
key, exit delay time starts to count down. You should leave before exit
delay time expires. Leaving after exit delay expires causes an alarm
event.
1. Make sure all points are normal (not faulted). Press the [9] key.
The display shows:
2. If all points are normal, exit delay time begins. You should leave
now. If your system has a faulted point, its point light blinks. You
should return the point to normal, or refer to Bypassing Points
(on page 16).
3. During exit delay, you may stop the system from turning on by
pressing [CLEAR].
4. When exit delay time expires, the keypad beeps three times, and
the system turns on.
5. To turn the system off, enter your personal passcode.
12