Identifying External Components; Front Panel; Rear Panel - TRENDnet TEG-448WS User Manual

IDENTIFYING EXTERNAL COMPONENTS

This chapter describes the front panel, rear panel, and LED indicators
of the Switch.

Front Panel

The figure below shows the front panel of the Switch.
Figure 4. Front panel of 48-port Gigabit Ethernet Switch
LED Indicator:
Comprehensive LED indicators display the status of the switch and
the network (see the LED Indicators chapter below).
1000BASE-T Gigabit Ethernet Ports (Port 1~48):
The Switch has 48 auto-negotiation, auto-MDIX Gigabit ports
can operate in half-duplex mode for 10/100Mbps and full-duplex mode for
10/100/1000Mbps.
Note: When the port is set to "Forced Mode", the Auto-MDIX will
be disabled.
mini-GBIC Ports (Port 45F~48F)
The Switch is equipped with four mini-GBIC ports.
support optional 1000BASE-SX/LX mini-GBIC module.
Port 45, 46, 47 and 48 are shared with the mini-GBIC 45F, 46F, 47F
and 48F ports. When you plug in a mini-GBIC module, the device the
RJ-45 port will be disabled.
.
These ports
The ports
11
Reset:
The Reset button reset settings back to factory default.
Note: Please make sure you copy down or save settings before
pressing "Reset" button.

Rear Panel

The rear panel of the Switch consists of an AC power connector. The
following shows the rear panel of the Switch
Figure 5. Rear panel of the Switch
AC Power Connector:
Plug in the female connector of the provided power cord into this
connector. Connect the male into a power outlet. Supported input
voltages range from 100-240V AC at 50-60Hz.
12