Configuring The Switch; Login - TRENDnet TEG-448WS User Manual

Under "View", there are 2 options; view log and clear log function.
View Log: Displays the event of the Web Management Utility
and the device.
Clear Log: Clears the log.
Under "Option", there is the Refresh Time option. This option allows
the user to set the refresh time for monitoring the device. The user can
choose 15 secs, 30 secs, 1 min, 2 min and 5 min.
Under "Help", About shows the version of the Web Management
Utility.

Configuring the Switch

The 48-Port 10/100/1000Mbps Gigabit Ethernet Web Smart Switch
has a Web GUI interface for smart switch configuration. The Switch
can be configured through the Web Browser. A network administrator
can manage, control and monitor the switch from the local LAN. This
section describes how to configure the various functions on the Switch
including:
Port Setting
Virtual LAN Group setting (VLAN)
Trunk
Port Mirroring
System Settings
Statistics

Login

Before you configure this device, make sure the PC is configured to
be in the same the subnet as the switch. For example, since the default
21
the default IP address of the Web Smart Switch is 192.168.0.1, then
the PC should be set to 192.168.0.x (where x is a number between 2
and 254), with a default subnet mask of 255.255.255.0.
Open Internet Explorer 5.0 or above.
Enter IP address http://192.168.0.1 (the factory-default IP address
setting) into the address bar.
You can also access the browser configuration through the Web
Management Utility. Select the desired Switch in the Monitor and
click "Access Web".
When the following dialog page appears, enter the default password
"admin" and click Login.
After entering the password, the system information screen will
appear.
Figure 13.
Figure 14.
22