Rack Mounting; Connecting Network Cable; Ac Power - TRENDnet TEG-448WS User Manual

Rack Mounting

The switch can be mounted in an EIA standard-size, 19-inch rack,
which can be placed in a wiring closet with other equipment. Attach
the mounting brackets at the switch's front panel (one on each side),
and secure them with the provided screws.
Figure 2. Combine the Switch with the provided screws
Then, use screws provided with the equipment rack to mount each
switch in the rack.
Figure 3. Mount the Switch in the rack
9

Connecting Network Cable

The Switch supports 10/100/1000Mbps Ethernet that runs in Auto-
negotiation mode, 10/100Mbps Ethernet that runs in half and full
duplex mode and 1000Mbps Gigabit Ethernet that runs in full duplex
mode using four pair of Category 5 Cable.
These RJ-45 ports are Auto-MDIX, allowing you to use either a
standard or crossover RJ-45 cable.
There are 4 additional mini-GBIC slots for optional mini-GBIC
modules.

AC Power

The Switch uses 100-240V AC, 50-60 Hz AC power. The switch's
power supply will adjust to the local power source automatically and
may be turned on without having any Ethernet cables connected.
10