Configuring Setup Settings; Port Settings - TRENDnet TEG-448WS User Manual

Figure 15. System Information

Configuring Setup Settings

There are seven options; Port Settings, IEEE 802.1Q VLAN Setting,
Trunk Setting, Mirror Setting, IEEE 802.1p Default Priority,
Broadcast Storm Control Setting and Jumbo Frame Setting

Port Settings

In Port Settings menu (Figure 16), this screen shows each port's status.
You can change the speed and flow control parameters by clicking on
the dropdown menu. If you want to update the link status, press the
"Refresh" button.
The Link Status in the screen will show the connection speed and
duplex mode. If there is no connection to the port, down will be
displayed.
23
Figure 16. Port Setting
Note 1: Be sure to click refresh after switching between media type (Fiber to Copper
or Copper to Fiber).
Note 2: The priority of Gigabit Fiber port is higher than Copper.
Speed/Disable:
There are six options—1000M Full, 100MFull, 100M Half, 10M
Full, 10M Half, Auto and Disable.
Flow Control:
This setting determines whether or not the Switch will be handling
flow control. Set Flow Control to Enable to avoid data transfer
overflow. Set Flow Control to Disable if flow control is not needed.
24