Installation Options; Features; Heating Specifications; Dimensions - Lopi LG FLUSH WOOD Owner's Manual

6

Installation Options:


Masonry Fireplace Insert
WARNING: Do not install this fireplace insert
into a factory-built metal (Z.C.) fireplace.

Heating Specifications:

Approximate Maximum Heating Capacity *
Maximum BTUs per Hour (Cord Wood Calculation)
Overall Efficiency (Oregon Method)
Maximum Burn Time
* Heating capacity will vary depending on the home's floor plan, degree of insulation, and the outside
temperature. It is also affected by the quality and moisture level of the fuel.
This model was not tested for efficiency however it is assigned a default efficiency of 63% by the EPA
under previous subpart AAA. Efficiency of this wood heater will be affected by the operational burn rate
and the moisture content of the wood used as fuel.

Dimensions:

Measure side clearances
from the side of the insert.
20-1/4"
515mm
Measure top
clearances from
the top plate.

Emissions:

This heater meets the 2015 U.S. EPA's crib wood emission limits for wood heaters sold after May 15,
2015. Tested to Method 28, 5H this heater has been shown to deliver heat at rates ranging from 12,000
to 45,100 BTU/hr and an emission value of 2.6g/h.
© Travis Industries
Features & Specifications
6" 153mm Diameter Flue
43-3/4"
1112mm
Measure front clearances
from the faceplate.

Features:


3.1 Cubic Foot Firebox Volume

Single Operating Control

Accepts Logs Up to 24" (610mm) Long

Steel Plate Construction (5/16" & 3/16") (8mm & 5mm)

Heavy Duty Refractory Firebrick

High-Tech Blower
1,200 SF to 2,250 SF(Extended)
74,300
70 %
Up to 12 Hours
5-5/8"
143mm
29-1/4" 743mm
15-3/4" 401mm
4-3/4"
121mm
Faceplate
100-01163
2
110 m to 210 m
Weight = 470 Lbs.
210 Kg.
21-3/4"
553mm
Electrical Line (may
be attached to the
opposite side)
Fireplace Opening
Figure 1
2
4150522