Installation Options; Features; Heating Specifications; Dimensions - Lopi Revere Owner's Manual

6

Installation Options


Masonry Fireplace Insert

Zero-Clearance (Metal) Fireplace Insert

Heating Specifications

Approximate Maximum Heating Capacity (in square feet)*
Maximum BTUs per Hour (Cord Wood Calculation)
Overall Efficiency (Oregon Method)
Maximum Burn Time
* Heating capacity will vary depending on the home's floor plan, degree of insulation, and the outside
temperature. It is also affected by the quality and moisture level of the fuel.
This model was not tested for efficiency however it is assigned a default efficiency of 63% by the EPA
under previous subpart AAA. Efficiency of this wood heater will be affected by the operational burn rate
and the moisture content of the wood used as fuel.

Dimensions

a Measure side
and top
clearances from
the top plate.
b Measure front
clearances from
the stove face.

Emissions

This heater meets the 2015 U.S. EPA's crib wood emission limits for wood heaters sold after May 15,
2015. Tested to Method 28, 5H this heater has been shown to deliver heat at rates ranging from 9,300 to
42,200 BTU/hr and an emission value of 1.9g/h.
© Travis Industries
Features & Specifications
Weight....380 Lbs. 170 Kg.
a
b
21-3/8"
24-1/4"
543mm
616mm
Figure 1
100-01339

Features


2.2 Cubic Foot Firebox Volume

Single Operating Control

Accepts Logs Up to 18" Long

Steel Plate Construction (5/16" & 3/16")

Heavy Duty Refractory Firebrick

Optional High-Tech Blower
1,200 to 2,000
72,400
70.4 %
Up to 10 Hours
5-3/16" 132mm
18-3/4"
477mm
10" 254mm
required hearth)
21-5/8" 550mm
19-3/4"
502mm
13-1/8" 334mm
ZC (metal) fireplaces require 1"
26mm clearance to the rear.
(does not include
4150520