Table of Contents
Advertisement
SAFETY NOTICE:
Please read this entire manual before you install and use your new room heater. Failure to
follow instructions may result in property damage, bodily injury, or even death. Contact
local building or fire officials about restrictions and installation inspection requirements in
your area.
Planning The Installation
We suggest that you have an authorized Travis Industries dealer install your fireplace insert. If you
install the fireplace insert yourself, your authorized dealer should review your installation plans.
Check with local building officials for any permits required for installation of this fireplace insert and
notify your insurance company before proceeding with installation.
The location of your wood heater in your home will decide how affectively the heat produced will spread
throughout your house. Attention to the home design with consideration of natural convection and air
circulation should be taken into account when choosing the placement of your heater within the home.
Preparation for Installation
Check for damage to the exterior of the fireplace insert (dents should be reported, scratches can be
fixed by applying touch-up paint).
Check the interior of the firebox (replace cracked firebrick and make sure baffle is in place).
The fireplace insert can be lightened by removing the firebricks and baffle (pg 28) - replace before
operation.
Additional Accessories Needed for Installation
a) Door Shell:
Black
Brass
Pewter
b) Surround Panels
Installation Considerations
Installation Type
Insert with Positive Flue (Full Reline)
(Page 13)
Insert with Direct Connect Flue
(Page 14)
Packing List
Wood moisture meter
Bypass Tool
© Travis Industries
Installation
(for qualified installers only)
99300175
99300176
99300177
100-01163
Considerations
• Provides best draft
• Easiest to clean
• Provides good draft
• Requires fireplace block-off plate - see page 11
7
4150522
Advertisement
Table of Contents
