Lopi LG FLUSH WOOD Owner's Manual page 34

34
Make sure the holes in the retainer line up with the holes on the shell then use a 5/16" nutdriver to
secure the shell with the two screws. Tighten until the door shell is snug against the retainer (do not
over-tighten).
5. Attach the door handle following the directions below.
6. Replace the door on the hinges and latch the door.
7. Attach the ashlip trim and side frames following the directions below.
Slide the ashlip trim
into place then
tighten the five set
screws on the
bottom of the ashlip
to secure.
1/16" Hex Wrench
© Travis Industries
Optional Equipment
5/16" Nutdriver
100-01163
NOTE: in rare cases the door retainer may not line u
the door shell, preventing the door handle from linin
correctly. To adjust the position horizontally, loosen
screws (see step 3) and adjust the door retainer pos
adjust vertically, remove the retainer and adjust the
the door shell (see step 2).
9/16" Wrench
Insert the screws
through the face and
nuts (the nuts are used
as spacers) and secure
to the side frames.
5/16"
Socket
Side Frame
4150522