Raw Port No - Oce cm3521 User Manual

Specifying settings from the control panel
Note
To cancel changes to the setting, touch [Cancel].

RAW Port No.

Specify the RAW port numbers used by the printer. By specifying multiple
port numbers, multiple data can be accepted simultaneously.
1
In TCP/IP Setting screen 5/5, touch [RAW Port No.].
The RAW Port Number screen appears.
2
Touch the button for the desired port.
3
Touch [ON] or [OFF].
4
To use the selected port, press the [C] (clear) key to erase the value,
and then use the keypad to type in the RAW port number (between 1
and 65535).
– If a value outside of the allowable range is specified, the message
"Input Error" appears. Type in a value within the allowable range.
5
Touch [OK].
The RAW port usage and RAW port numbers are set.
Note
When using the RAW port, set [Spool Print Job in HDD before RIP] to
[ON]. A timeout may occur if it is set to [OFF].
cm3521
3
3-53