Instrument Cluster And Speedometer Cable - Removal And Installation; Instrument Cluster - Yamaha TDM850 User Manual

14.9a Rear brake light switch (arrowed) -
TDM models
Rear brake pedal switch
9 The switch is mounted on the inside of the
right-hand footrest bracket
illustrations). Remove the seat for access to
the connector (see Chapter 8). Trace the
wiring from the switch and disconnect it at the
connector (see illustration). Free the wiring
from any clips or ties.
10 Detach the lower end of the switch spring
from the brake pedal, then unscrew and remove
the switch.
11 Installation is the reverse of removal. Make
sure the brake light is activated just before the
rear brake pedal takes effect. If adjustment is
necessary, hold the switch and
15.1a Release the clips from the
grommets and remove the surround
15.3b On TRX models, the wiring
connectors are located behind the steering
head
14.9b Rear brake light switch (arrowed) -
TRX models
turn the adjusting ring on the switch body until
the brake light is activated when required.
(see
15 Instrument cluster and
speedometer cable -
removal and installation

Instrument cluster

Removal
1 Remove the fairing (see Chapter 8). On TRX
models, remove the fuel tank and air filter
housing for best access to the wiring connectors
(see Chapter 4). On XTZ models,
15.1b On TRX models, remove the trim
that houses the wiring loom
15.3c Instrument cluster wiring connector
(arrowed) - XTZ models
Electrical system 9«11
14.9c Rear brake switch wiring connector
(arrowed) - TDM models
release the clips on the instrument cluster
surround from the grommets on the cluster and
remove the surround (see illustration). On TRX
models, remove the screws securing the trim
^
cover to free the wiring loom (see illustration).
§§
2 On all except 1999 TDM models, unscrew the
^
knurled ring securing the speedometer cable to
the back of the speedometer and detach the
cable (see illustration 15.6a).
3 Disconnect the instrument cluster wiring
connector(s) (see illustrations).
4 Unscrew the nuts securing the instrument
cluster to the bracket and lift the cluster off,
noting how it fits (see illustrations).
15.3a Instrument cluster wiring
connectors - TDM models
15.4a Unscrew the nuts (arrowed)...
Started by Stalker