Fainng - Removal And Installation - Yamaha TDM850 User Manual

5.2a Remove the screws and bolts (arrowed)...
5 Fainng -
removal and installation
fr-
1991 to 1995 TDM models
Removal
1 Remove the fairing side panels (see Section 4).
2 Remove the two screws and two bolts
securing the fairing (see illustration) on each
side. Carefully draw the fairing up and forward
until the auxiliary light bulbholder becomes
accessible, then remove it from the auxiliary light
and remove the fairing (see illustrations).
Installation
3 Installation is the reverse of removal. Make
sure the wiring connector is correctly and
securely connected.
1996-on TDM models
Removal
4 Remove the fairing side panels {see Section
4). Remove the three screws securing the
instrument cluster cover and remove the cover
and the foam damper (see illustration).
5 Remove the screws securing the windshield
and remove the windshield. Ease the rubber
expanders out of the windshield mounting points
in the fairing.
5.2c ... and remove the fairing
1
^
1 Instrument cluster cover
2 Foam clamper
3 Windshield screw -6 off
4 Rubber expander -
6 off
5.2b ... then draw the fairing forward and remove the auxiliary light
bulbholder...
5.4 Fairing mountings
5 Cockpit trim
panel
6 Screw -4 off
7 Headlight connector
8 Auxiliary light connector
Bodywork 8*5
9 Turn signal connectors
10 Turn signal retaining nuts
11 Fairing mounting screw -
2 off
12 Fairing mounting nut -4 off
Started by Stalker
8