Engine Bashplate (1991-95 Tdm And All Xtz) - Removal And Installation - Yamaha TDM850 User Manual

5.15 Disconnect the headlight wiring
connector (A) and the auxiliary light wiring
connector (B) for each light
XTZ models
Removal
14 Remove the fairing side panels (see
Section 4).
15 Disconnect the headlight wiring
connectors and the auxiliary light wiring
connectors (see illustration).
16 Remove the three nuts securing the fairing
and headlight to the bracket. Carefully draw
the fairing forward and remove it along with
the headlight (see illustration). If required, lift
the headlight out of the fairing.
Installation
17 Installation is the reverse of removal.
3.2b Mudguard mounting bolts (arrowed)
TRX models
7.1 Engine bashplate mountings - TDM
models
^m ■ •Mr
. M
t
I . v
5.16 The headlight comes away with the fairing
Make sure the wiring connectors are correctly the
and securely connected. Check that the
headlights and auxiliary lights are all
working.
(see illustrations).
6 Front mudguard -
Installation
removal and installation
3
Removal
1 On 1991 to 1995 TDM models, unscrew the
knurled ring securing the speedometer to the drive
housing on the front wheel, then detach
6.2c On XTZ models, the bolts (arrowed)
on the inside of the fork leg
are
7.2a The bashplate is secured by a
bolt (arrowed) on each side at the
front...
Bodywork 8*7
6.2a On TDM models, note how the
mounting brackets fit
cable and draw it up through the guide on
the mudguard.
2
mudguard to the holder on each fork slider
and remove the mudguard, noting how it fits
on is the reverse of removal.
is Is
7 Engine bashplate
(1991-95 TDM and all XTZ)- |§
removal and installation
Removal
1 On TDM models, remove the cap from the
end of the through-bolt, then remove the split
pin and washer and withdraw the bolt (see
illustration). Unscrew the two bolts on the
bottom of the plate and remove the bashplate,
noting how it fits.
2 On XTZ models unscrew the four bolts
securing the bashplate to the frame and
engine and remove the plate, noting how it fits
(see illustrations).
Installation
3 Installation is the reverse of removal.
7.2b .. and on each side underneath
UNREGISTERED VI
Unscrew the four bolts securin
Installati
i
j^
8
Scaned by Stalker
UNREGISTERED VERSION OF PICTURE-DESK