Yamaha TDM850 User Manual page 145

13.9a Remove the blanking caps if
fitted ...
7 On TDM models, unscrew the nut and
withdraw the bolt securing the bottom of the
shock absorber to the swingarm
illustrations 10.3a and b).
8 On TRX and XTZ models, remove the rear
shock absorber (see Section 10). If required,
remove the linkage rods from the swingarm (see
Section 11).
9 Where fitted, remove the blanking cap from
each end of the swingarm
illustration). Unscrew the nut on the end of the
swingarm pivot bolt and remove the washer,
where fitted (see illustration).
10 Support the swingarm, then withdraw the
pivot bolt and remove the swingarm (see
13.11 Remove the chain slider if required
13.14c ... and grease the bearings and
other components as described
13.9b ... then unscrew the swingarm nut
(arrowed) - TDM shown
illustration). Knock the pivot bolt through using
a drift if required.
(see 11 Remove the chain slider from the front of the
swingarm if necessary, noting how it fits (see
illustration). If it is badly worn or damaged, it
should be renewed.
12 Inspect all components for wear or damage
as described in Section 14.
Installation
pivot (see
13 If removed, install the chain slider and
tighten its bolt(s) securely (see illustration
13.11).
14 Remove the cap and washer (where fitted)
from each side of the swingarm, and withdraw
13.14a Remove the cap and washer
(where fitted)...
13.15a Do not forget to loop the chain
over the swingarm
i, suspension and final drive 6*25
13.10 Withdraw the pivot bolt and remove
the swingarm - TDM shown
the bearing spacer(s) (see illustrations).
Lubricate the seals (XTZ models) and bearings
with molybdenum disulphide grease
models) or lithium-based grease (XTZ models).
Also grease the collar(s) and swingarm pivot.
Re-install the washers and caps.
15 Offer up the swingarm, and have an assistant
hold it in place (see illustration). Make sure the
drive chain is looped over the front of the
swingarm. Slide the pivot bolt through the
swingarm (see illustration 13.10), on TDM
models making sure the flats on the head of the
pivot bolt locate correctly with the flats in the
frame (see illustration). Install the
13.14b ... then withdraw the collar...
13.15b On TDM models, make sure the
bolt head flats locate correctly
rUHREGISTERED VERSION OF PICTURE-DESK
(TRX
Staned by Stalker
UNREGISTERED VERSION OF PICTORE-DESK