Set Top Of Form And Page Length; Set Top Of Form; Set Page Length In Inches; Set Page Length In Lines - Lexmark FORMS 249X Technical Reference

Set Top of Form and Page Length

Set Top of Form

This command sets the first line of printing on each page to the current paper
position.
Format
Decimal
Hex

Set Page Length in Inches

This command sets the page length to a specified number of inches.
Format
Decimal
Hex
Usage Notes
• The value of n is the number of inches you want to set as the page length
and must be between 1 and 255.
• When the command is sent, the current vertical position becomes the new
top of form.
• If the printer command Set Skip Perforation (ESC N) is active, or if "skip
over perforation" is On in the printer setup, this printer command deacti-
vates it.

Set Page Length in Lines

This command sets the page length to a specified number of lines.
Format
Decimal
Hex
Usage Notes
• The value of n is the number of lines you want to set as the page length and
works in conjunction with the current line spacing (ESC A).
ESC 4
27 52
1B 34
ESC C 0 inches
27 67 0 n
1B 43 00 n
ESC C lines
27 67 n
1B 43 n
Section 3: IBM Emulation Mode Printer Commands
59