•
When the command is sent, the current vertical position becomes the new
top of form.
•
If the printer command Set Skip Perforation (ESC N) is active, or if "skip
over perforation" is On in the printer setup, this printer command deacti-
vates it.
Set Skip Perforation
This command specifies the number of lines to be skipped at the bottom of each
page, which creates a bottom margin.
Format
Decimal
Hex
Usage Notes
•
This command remains in effect until:
— Cancel Skip Perforation (ESC O) printer command is received.
— Set Page Length in Lines (ESC C) printer command is received.
— Set Page Length in Inches (ESC C 0) printer command is received.
•
Valid values for n are 1 through 255 (decimal), 01 through FF
(hexadecimal).
•
To cancel this printer command, use Cancel Skip Perforation (ESC O).
Cancel Skip Perforation
This command cancels Set Skip Perforation (ESC N).
Format
Decimal
Hex
60
Section 3: IBM Emulation Mode Printer Commands
ESC N
lines
27
78
n
1B
4E
n
ESC O
27
79
1B
4F