Table of Contents
Advertisement
5055-01x
6. Remove the screw from the OHP detection sensor (upper).
7. Turn the bearing stopper of the multi-purpose feeder roll forward
1/4 turn and remove upward.
8. Remove the C-clip and remove the multi-purpose feeder clutch.
Note: After reassembling the components, coat the contact areas of
the multi-purpose feeder roll shaft and multi-purpose feeder ground
plate with conductive grease. If the paper feed roller surface is
stained by oil or other contaminant, clean with cloth moistened with
alcohol.
4-24
Service Manual
Advertisement
Table of Contents
