Printing Photos From A Pictbridge-Enabled Digital Camera; Printing Information Pages; Printing A Font Sample List - Lexmark 280 User Manual

Printing photos from a PictBridge-enabled digital
camera
You can connect a PictBridge-enabled digital camera to the printer, and use the buttons on the camera to select and
print photos.
1
Insert one end of the USB cable into the camera.
Note: Use only the USB cable that came with your camera.
2
Insert the other end of the USB cable into the USB port on the front of the printer.
Notes:
Make sure the PictBridge-enabled digital camera is set to the correct USB mode. See the camera
•
documentation for more information.
If the PictBridge connection is successful, then a confirmation message appears on the printer display.
•
3
Follow the instructions on the camera to select and print photos.
Note: If the printer is turned off while the camera is connected, then you must disconnect and then reconnect the
camera.

Printing information pages

Printing a font sample list

To print samples of the fonts currently available for your printer:
1
Make sure the printer is on and Ready appears.
2
From the printer control panel, press
3
Press the down arrow button until Reports appears, and then press
4
Press the down arrow button until Print Fonts appears, and then press
5
Press the down arrow button until
.
After the font sample list prints, Ready appears.
.
appears next to PCL Fonts or PostScript Fonts, and then press
Printing
76
.
.