Menu item
Run Initial setup
Yes
No
Paper Sizes
U.S.
Metric
Scan to PC Port Range
<port range>
Default Mode
Copy
Fax
Date Format
MM-DD-YYYY
DD-MM-YYYY
YYYY-MM-DD
Time Format
12 hour A.M./P.M.
24 hour clock
Alarms
Alarm Control
Cartridge Alarm
Timeouts
Power Saver
Disabled
1–240
Timeouts
Screen Timeout
15–300
Description
Instructs the printer to run the setup wizard
Notes:
Yes is the factory default setting.
•
After completing the setup wizard by selecting Done at the
•
Country select screen, the default setting becomes No.
Specifies the printer factory default measurements. The default
setting is determined by the country selection in the initial setup
wizard.
Specifies a valid port range for printers behind a port blocking
firewall. The valid ports are specified by two sets of numbers
separated by a semicolon.
Note: 9751:12000 is the factory default setting.
Sets the function the printer enters when Go, Content, Darkness,
or any number is pressed on the printer control panel
Note: Copy is the factory default setting
Formats the printer date
Note: MM-DD-YYYY is the US factory default setting and
DD-MM-YYYY is the international factory default setting.
Formats the printer time
Note: The factory default setting is 12 hour A.M./P.M.
Sets an alarm to sound when the printer requires operator
intervention. Available selections for each alarm type are:
Off
Single
Continuous
Notes:
Single is the factory default setting for Alarm Control. Single
•
sounds three quick beeps.
Off means no alarm will sound.
•
Continuous repeats three beeps every 10 seconds.
•
Specifies the number of minutes of inactivity before some systems
begin entering a minimum power state.
Note: 30 minutes is the factory default setting.
Sets the amount of time in seconds the printer waits before
returning the printer display to a Ready state
Note: 30 seconds is the factory default setting.
Understanding printer menus
138