Planet MH-3400 User Manual page 33

Item
User Name
Password
Connect on Demand
Keep Alive
Enable Line-Dropped
Scheduling
Line-Dropped Period
Line-Dropped
Scheduling
Link Backup Interface
Shared- Circuit WAN
environment
MTU
Gigabit Multi-Homing VPN Security Router User's Manual
Description
Input the user name issued by ISP.
Input the password issued by ISP.
This function enables the auto-dialing function to be used in a PPPoE dial
connection. When the client port attempts to connect with the Internet, the
device will automatically make a dial connection. If the line has been idle for a
period of time, the system will break the connection automatically. (The default
time for automatic break-off resulting from no packet transmissions is five
minutes).
This function enables the PPPoE dial connection to keep connected, and to
automatically redial if the line is disconnected. It also enables a user to set up a
time for redialing. The default is 30 seconds.
The WAN disconnection schedule will be activated by checking this option. In
some areas, there is a time limitation for WAN connection service. For
example: the optical fiber service will be disconnected from 0:00 am to 6:00 am.
Although there is a standby system in the device, at the moment of WAN
disconnection, all the external connections that go through this WAN will be
disconnected too. Only after the disconnected lines are reconnected can they
go through the standby system to connect with the Internet. Therefore, to avoid
a huge number of disconnections, users can activate this function to arrange
new connections through another WAN to the Internet. In this way, the effect of
any disconnection can be minimized.
Input the time rule for the disconnection of this WAN service.
Input how long the WAN service may be disconnected before the newly added
connections should go through another WAN to connect with the Internet.
Select another WAN port as link backup when port binding is configured. Users
should select the port that employs the same ISP.
If your WAN connects to a Switch, select "Enabled" to filter broadcast packets.
The default is "Disabled".
MTU is abbreviation of Maximum Transmission Unit. "Auto" and "Manual" can
be chosen. The default value is 1500. Different value could be set in different
network environment. (e.g. ADSL PPPoE MTU: 1492) .The default is "Auto".
- 27 -