Gas Conversion - Vermont Castings Intrepid INDVRCB Homeowner's Installation And Operating Manual

Pilot Assembly
Fig. 73 Pilot Assembly location.
• Remove pilot orifice with Allen wrench. (Fig. 75)
• Install the conversion orifice.
ST935
• Reinstall pilot hood. Be sure to align hood with in-
SDDVT
dex tab.
pilot location
6/07
Pilot Hood
Pilot
Bracket
Fig. 74 Remove pilot hood.
Index Tab
CO105a

gas conversion

Pilot
Snap Ring
1/28/00 djt
Fig. 75 Remove pilot orifice.
Pilot type 2
• Loosen pilot hood turning counterclockwise using a
7/16" wrench. (Fig. 76) NOTE: You may use pene-
trating oil to prevent pilot hood threads from seizing
CO106a
up.
• Remove pilot orifice with needlenose pliers. (Fig.
DV360/580
77) NOTE: Use a wrench to hold pilot tube in place
Gas Conversion
while removing the orifice.
Pilot2
• Install the conversion orifice.
1/28/00 djt
• Reinstall pilot hood and tighten until mark on pilot
hood aligns with mark on pilot bracket.
20012761
ST935
CO105a
Allen Wrench
CO106a
Intrepid® Direct Vent - Rear Vent Gas Heater
Index
Marks
Pilot Bracket
Fig. 76 Remove pilot hood. (Your pilot may have a different
appearance.)
Fig. 77 Remove pilot orifice.
Burner Orifice Conversion
1. Remove three (3) 3/8" nuts on bottom side of burner
pan. (Fig. 78)
2. Carefully remove ember bed by tilting the right side
up and lifting out toward the right side of the unit. (Fig.
79)
Bottom View
Remove Nuts
Fig. 78 Remove three (3) nuts securing ember bed in place.
3. Remove injector orifice from left burner bracket with a
1/2" wrench.
4. Install conversion orifice. (Refer to Table 3)
5. The air shutter is factory set according to table on
Page 7 and should not need adjustment. The air
shutter opening may be verified by measuring as
shown in Figure 80.
Pilot Hood
CO105
Pilot
CO105
Orifice
Gas Conversion
Pilot
2/15/99 djt
CO106b
CO106a
Gas Conversion
Pilot (Vermont)
7/19/99 djt
Remove Nut
ST918
35