Operation; Your First Fire; Pilot And Burner Inspection; Flame & Temperature Adjustment - Vermont Castings Intrepid INDVRCB Homeowner's Installation And Operating Manual

Intrepid® Direct Vent - Rear Vent Gas Heater
4. Install top log by mating hole on
bottom of log with locating pin on
top right side of rear log. (Fig. 61)
Position log so it is angled down
toward the area where the front
two logs meet.
The Intrepid is operated with the operable door front plate
in place with the doors open or closed. To open the front
doors, pull either door toward you.

Your First Fire

Read these instructions carefully and familiarize yourself
with the burner controls shown in Figure 62. Locate the
pilot assembly, Figure 63. Follow the lighting instructions
on Page 32 exactly.
During the first fire, it is not unusual to smell some odor
associated with new logs, paint and metal being heated.
Odors should dissipate within a few hours. You can open
a window to provide fresh air to alleviate the condition.
Manifold Pressure Tap
Pilot Adjustment
Screw
Fig. 62 NOVA SIT valve control.
30
Figure 61
Left Log

Operation

Inlet Pressure Tap
Gas Control
Regulator
Knob
Control Knob
ST941
Back Log
Ember Bed
Pilot Assembly
Fig. 63 Pilot Assembly location.

Pilot and Burner Inspection

ST935
Each time you light your heater check that the pilot flame
SDDVT
and burner flame pattern are as shown in Figure 65. If flame
pilot location
patterns are incorrect, turn the heater off. Contact your
dealer or a qualified gas technician for assistance. Do not
6/07
operate the heater until the pilot flame is correct.
Follow regular maintenance procedures as described on
Page 37.
Flame & Temperature Adjustment
For stoves equipped with HI/LO valves, flame adjustment is
accomplished by rotating the HI/LO adjustment knob located
near the center of the gas control valve. (Fig. 64)
Top Log
LG499
Right Log
ST935
20012761