Resetting The Receiver To Default - ActionTec SBWD100B User Manual

3. Click OK on the pop-up message box to confirm.

5.3.23. Resetting the Receiver to Default

Follow the procedure below to reset the receiver to the default settings:
1. Go to the Maintenance tab page by clicking the Maintenance tab.
2. Click the Yes button next to "Reset Settings to Factory".
3. Click OK on the pop-up message box to confirm.
4. The receiver reboots, and the receiver is reset to factory defaults after the reboot.
Note: You can also reset your receiver to default by pressing the "Reset" button. Follow the
procedure below to restore the Receiver's default factory settings:
1. Power on the Receiver, and wait until the "Ready to connect" screen appears.
2. Hold down the Receiver's "Reset" button with a pin.
3. When the "Reset to Default" screen appears on the HDTV, release the "Reset" button.