ActionTec SBWD100B User Manual page 47

before downloading firmware.
7. Extract the zip file. You will find one "autorun" folder and one "install.img" file in the
extracted file folder.
8. Insert a USB flash drive to your laptop/PC.
9. Copy the "autorun" folder and the "install.img" file to the root directory of the USB flash
drive.
Note: Do not use a portable hard drive. You should use a FAT/FAT32 formatted USB
flash drive only.
10. Power on your Receiver. Make sure the "Ready To connect" screen appears on your
TV.
Note: You must disconnect your device (laptop, ultrabook, smartphone or tablet) from
the receiver before upgrading your receiver.
11. Safely remove your USB flash drive from your PC, and plug it into the USB port of
ScreenBeam Pro.
12. The Receiver starts to update its firmware automatically. Firmware upgrade status
messages appear on your TV.
Warning! Do not power off the Receiver or remove the USB flash drive while the
upgrade is in progress. Otherwise, firmware upgrade fails.
13. The Receiver reboots. Firmware upgrade completes after the "Ready to connect"
screen appears again.
14. Upgrade completes. You may now remove the USB flash drive from the Receiver.