Modifying The Receiver's Wireless Network Name (Ssid) - ActionTec SBWD100B User Manual

address is displayed in the lower part of the Ready to connect screen. It is used to
access the local management server when AGO is disabled.
Note: The Wireless IP Address must not be in the range defined by Wireless DHCP IP
Start and Wireless DHCP IP End.
Wireless Subnet Mask: It is the subnet mask of receiver's network.
Wireless DHCP IP Start and Wireless DHCP IP End: These two items define the range
of IP addresses assigned to the connected devices.
Note: These network parameters works when AGO is disabled.
3. Click the Apply button, and then click OK on the pop-up message box to confirm.
4. The receiver reboots, and new settings take effect after the reboot.

5.3.21. Modifying the Receiver's Wireless Network Name (SSID)

When AGO is disabled, you can modify the receiver's wireless network name (SSID).
Follow the procedure below to modify the receiver's SSID:
1. Go to the Network Settings tab page by clicking the Network Settings tab.
2. Go to the Network Name (SSID) and Network Password section, and type a new name
in the Network Name (SSID) box and a new password in Network Password box.