Target: Map1/Enetport1/Lanendpt1/Ipendpt1; Target: Map1/Dhcpendpt1; Ipendpt1 Properties; Dhcpendpt1 Properties - HP ntegrity iLO 2 MP Operation Manual

cd Changes the current default target.
help Displays context-sensitive help.
show Displays information.

Target: map1/enetport1/lanendpt1/ipendpt1

The ipendpt1 target represents the iLO IP endpoint settings.
Table 6-43 shows ipendpt1 target properties.
Table 6-43 ipendpt1 Properties
Property Name
IPv4Address
SubnetMask
AddressOrigin
Verbs
cd Changes the current default target.
help Displays context-sensitive help.
show Displays information.
set Sets a property to a specific value.

Target: map1/dhcpendpt1

The dhcpendpt1 target represents the iLO 2 MP DHCP client.
Table 6-44 shows dhcpendpt1 target properties.
Table 6-44 dhcpendpt1 Properties
Property Name
EnabledState
OtherTypeDescription
Verbs
cd Changes the current default target.
help Displays context-sensitive help.
show Displays information.
start Enables iLO 2 MP DHCP.
stop Disables iLO 2 MP DHCP.
Description
iLO 2 MP IP address.
iLO 2 MP subnet mask.
Used to indicate the configuration
method that resulted in the
configuration being assigned to this
ipendpt.
Description
Represents the state of iLO 2
MP DHCP.
Textual description of this
protocol endpoint.
SMASH Server Management Command Line Protocol
Access and Values
Read/write
The value of the property must be expressed
in dotted decimal notation.
Read/write
The value of the property must be expressed
in dotted decimal notation.
Read-only
The following are valid values:
Static: The iLO 2 MP IP address and subnet
mask were assigned statically.
DHCP: The iLO 2 MP IP address and subnet
mask were acquired using DHCP.
Access and Values
Read-only
The following are valid values:
Enabled: The iLO 2 MP DHCP client is enabled.
Disabled: The iLO 2 MP DHCP client is disabled.
Read-only
Set to DHCP.
139