Table of Contents
Advertisement
Table 6-29 Supported Command Verbs (continued)
Command
help
load
reset
set
show
start
stop
version
The following verbs are available for execution from any target:
•
show
•
help
•
cd
•
version
•
exit
Command Targets
The command target address identifies the specific managed element or association to be affected
by the command verb. All SM CLP commands have a command target, whether explicitly or
implicitly identified.
For instance, the target /map1/telnetsvc1/ can be identified in any of the following ways:
Using the target's absolute path:
</> hpiLO-> show /map1/telnetsvc1
Using the target's relative path form map1 target:
</map1> hpiLO-> show telnetsvc1
Using implicit (current) target's with the verb show
</map1/telnetsvc1> hpiLO-> show:
Command Target Properties
Target properties are identifying and descriptive information related to and defined by the target.
Target properties are identified by property names. Each class of target defines a set of valid
property names. Property values are expressed in name=value format.
You can specify one or more properties on the command line. If you specify multiple properties
on the same command line, they must be separated by a space.
Displays context-sensitive help.
help displays general help and all supported commands.
help <some verb> displays help for the specified verb.
help <some target>displays help for the specified target.
help <some property> displays help for the specified property.
Moves a binary image to iLO 2 MP from a URI.
Causes a target to cycle from enabled to disabled and back to enabled.
Sets a property to a specific value.
Displays information about managed elements (targets, their supported properties and verbs).
You can also run the show command with an explicit or implicit target. For more information on
implicit and explicit targets, see
"Command Targets" (page 127)
.
Causes a targeted object to change its state to a higher level.
Causes a targeted object to change its state to a lower level.
Queries the version of the SM CLP implementation.
Action
"System1 Target" (page
130),
SMASH Server Management Command Line Protocol
"Map1 (iLO 2) Target" (page
131),
127
Advertisement
Table of Contents
