Setup Smi-S Environment - Fujitsu ETERNUS DX60 S3 User Manual

Chapter 1 System Management
1.4 System Management
1.4.6

Setup SMI-S Environment

This function enables or disables the Storage Management Initiative - Specification (SMI-S).
SMI-S is a standard specification concerning storage management technologies by Storage Networking
Industry Association (SNIA).
When enabling the SMI-S, the ETERNUS DX can be managed from general storage management applications
that support the SMI-S.
• When switching the SMI-S setting between enabled or disabled, reboot the ETERNUS DX (for the control-
ler firmware versions V10L2x and earlier).
• If enabling or disabling of the SMI-S is being performed, the [Setup SMI-S Environment] action cannot be
clicked (for the controller firmware versions V10L3x and later).
• This function can be used to check the current SMI-S setting. Refer to "System Settings" in "ETERNUS Web
GUI User's Guide (Operation)" for details.
• For the controller firmware versions V10L3x and later, one of the following buttons is displayed.
- A [Stop] button (if the current SMI-S setting is "Enable")
- A [Start] button (if the current SMI-S setting is "Disable")
For details on the parameters for the [Setup SMI-S Environment] function of the controller firmware version
V10L2x or earlier, refer to
earlier)" (page
For the factory default settings for this function, refer to
The procedure to enable or disable the SMI-S function is as follows:
■ Enabling or disabling the SMI-S function when the controller firmware version is V10L2x or
earlier (ETERNUS DX60 S3)
Procedure
1
Click [Setup SMI-S Environment] in [Action].
"A.1.3.6 Setup SMI-S Environment (for Controller Firmware Version V10L2x or
678).
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
"Appendix B Setup SMI-S Environment" (page
43
973).
P2X0-1270-13ENZ0