Fujitsu ETERNUS DX60 S3 User Manual page 384

Chapter 4 Connectivity Management
4.2 Host Group Management
(4)
Click the [OK] button
 Returns to the [Manual Input] screen.
(5)
Repeat
If an error screen appears under the following conditions, check the parameter settings.
• The "Host Group Name" is not entered
• The "Host Group Name" does not satisfy the input conditions
• The "Host Group Name" overlaps with an existing host group name
(Host group names cannot overlap with any other host group names, irrespective of the interface
types.)
• The several SAS hosts with the same SAS addresses have been registered
• Nine or more hosts are registered in the host group or no hosts are registered in the host group
• The total number of host groups has exceeded the maximum number for the ETERNUS DX
• The total number of hosts has exceeded the maximum number for the ETERNUS DX
• A host with an unrecognizable LUN is added
(6)
After adding the SAS host is complete, click the [Add] button.
 A confirmation screen appears.
4
Click the [OK] button.
 Registration of the SAS host group starts.
5
Click the [Done] button to return to the [Host Group] screen.
Click the [Continue] button to continue registering SAS host groups.
Step (2) through Step (4) to set more SAS addresses.
384
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
End of procedure
P2X0-1270-13ENZ0