Setup Snmp Manager - Fujitsu ETERNUS DX60 S3 User Manual

Chapter 1 System Management
1.8 Network Management
1.8.4

Setup SNMP Manager

This function specifies the IP address of the SNMP Manager.
The SNMP Manager is used when accessing the ETERNUS DX using the community name or the user name, or
when sending a trap from the ETERNUS DX to the SNMP Manager.
Up to ten SNMP Managers can be specified for each ETERNUS DX.
• If the "SNMP Function" is disabled, this function cannot be used.
• The IP address of the SNMP Manager that is used in the settings in
(page 120)
• When SNMP Manager exists in a different subnetwork from where the ETERNUS DX belongs, specify the IP
address or the network address of SNMP Manager in "Allowable IP Address" using the procedure in
Setup Network Environment" (page
For details on the parameters for this function, refer to
For the factory default settings for this function, refer to
The procedure to set the SNMP Manager is as follows:
Procedure
1
Click [Setup SNMP Manager] in [Action].
2
When adding a Manager IP address, click the [Add] button. Click the [Manager] link to edit
the Manager IP address.
To delete the existing Manager IP address, click the [Delete] button for the target IP address.
 The [Manager] screen appears.
or "1.8.8 Setup SNMP Agent Trap" (page 123)
97).
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
"1.8.7 Setup SNMP Agent Community"
cannot be changed or deleted.
"A.1.7.4 Setup SNMP Manager" (page
"Appendix B Setup SNMP Manager" (page
113
"1.8.1
711).
980).
P2X0-1270-13ENZ0