Setup Snmp Agent Community - Fujitsu ETERNUS DX60 S3 User Manual

Chapter 1 System Management
1.8 Network Management
6
After adding or editing the user, click the [Set] button.
 A confirmation screen appears.
7
Click the [OK] button.
 Setting of the SNMP Agent user starts.
8
Click the [Done] button to return to the [Network] screen.
1.8.7

Setup SNMP Agent Community

This function sets up the SNMP Agent Community.
The Community is a range of available networks for SNMP.
The setting value is used as the password for SNMP Manager to access the SNMP Agent of the ETERNUS DX.
The SNMP Agent only accepts a request from SNMP Manager if the specified community names for SNMP
Manager and SNMP Agent are the same.
Up to ten communities can be specified for each ETERNUS DX.
• If the "SNMP Function" is disabled, the [Setup SNMP Manager] function cannot be used.
• The community name that is used in the settings in
changed or deleted.
• This function must be used when using SNMPv1 or SNMPv2c in SNMP communication between the SNMP
Agent and the SNMP Manager. This setting is not necessary when using SNMPv3 only.
The SNMP Managers which are allowed to access, and the MIB access range, can be specified for each
community.
120
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED
"1.8.8 Setup SNMP Agent Trap" (page 123)
End of procedure
cannot be
P2X0-1270-13ENZ0