Delete Advanced Copy License - Fujitsu ETERNUS DX60 S3 User Manual

Chapter 7 Advanced Copy Management

7.4 Delete Advanced Copy License

7.4 Delete Advanced Copy License
This function deletes all of the Advanced Copy licenses registered in the ETERNUS DX.
• An Advanced Copy license cannot be deleted in the following conditions:
- The CM status is not normal
- SDVs or SDPVs are registered
- A volume that is Advanced Copy protected exists
- An Advanced Copy session (except for an ODX session, an XCOPY session, or a Virtual Volume session)
exists
- An Advanced Copy table size has been configured
- An REC Buffer has been configured
- An REC Disk Buffer has been created
• Do not delete the Advanced Copy license when the Storage Cluster function is being used. If the Storage
Cluster function is enabled but is not being used, the Advanced Copy license can be deleted under the
following conditions.
- An Advanced Copy path has been configured
- A port with the RA mode exists
- A port with the CA/RA mode exists
• If the Unified Storage is enabled, the Advanced Copy license can also be deleted under the following
conditions.
- A SnapOPC+ session for the Snapshot function exists
- SDVs (only the Snapshot destination SDVs) are registered
• Rebooting the ETERNUS DX is required after deleting an Advanced Copy license.
To check whether the Storage Cluster function is enabled or disabled, use the [System] screen. Refer to
"System (Basic Information)" in "ETERNUS Web GUI User's Guide (Operation)" for details.
The procedure to delete an Advanced Copy license is as follows:
Procedure
1
Click [Delete License] in [Action].
 A confirmation screen appears.
598
ETERNUS Web GUI User's Guide (Settings)
Copyright 2015 FUJITSU LIMITED P2X0-1270-13ENZ0