Foot Holder - Janome QS2250 Instruction Manual

Janome 2250 Instruction Manual

Foot Holder

www.aaasewing.com
(Example)
A. To remove and attach the Snap-On
type presser foot
To remove:
Raise the needle to its highest position by turning
the handwheel counterclockwise.
Raise the presser foot, and press the lever on the
back of the foot holder.
To attach:
Place the selected presser foot so the pin on the
foot lies just under the groove of the foot holder.
Lower the presser bar to lock the foot in place.
B. To remove the foot holder and attach
the presser foot or attachment
To remove the foot holder:
1. Disconnect the power supply plug.
2. Loosen the setscrew and remove the
foot holder.
3. Remove the setscrew.
To attach:
4. Align the slot in the foot holder with
the threading hole in the presser bar.
5. Tighten the screw by turning it toward
you.
1
QS2250 Owners Manual/ User Guide