Removing And Attaching The Foot Holder; Dual Feed Foot - Janome Horizon Memory Craft 8200 QCP Special Edition Instruction Book

q
w
e
w
z
q
x
e
r

Removing and Attaching the Foot Holder

Always make sure to press the lockout key to lockout
the machine or turn the power switch off before
replacing the presser foot.
Removing the foot holder
Raise the needle to its highest position.
Raise the presser foot and loosen the setscrew.
Remove the foot holder.
q Presser bar
w Foot holder
e Setscrew
q
Attaching the foot holder
Attach the foot holder to the presser bar from the rear.
Tighten the thumbscrew securely with the screwdriver.
NOTE:
Lower the presser foot when loosening and tightening
the thumbscrew if it is hard to access.
e

Dual Feed Foot

Always make sure to press the lockout key to lockout
the machine or turn the power switch off before
replacing the presser foot.
w
z Raise the needle to its highest position.
x Loosen the setscrew.
14
CAUTION:
CAUTION:
Raise the presser foot lifter.
q Presser foot lifter
w Needle
Remove the foot holder.
e Foot holder
r Setscrew