Table of Contents
Advertisement
INSTALLING OR REMOVING PAD
DRIVER OR PADS
Consult an authorized distributor to assist you in
selecting the correct pad for your specific needs.
Pad driver installation:
1. Tip machine on the right side (dip stick down).
2. Place pad driver on drive shaft and spin pad
driver clockwise to install.
Pad Removal & Installation:
1. Tilt machine back on rear caster or service
position.
2. Remove center-lock from pad driver.
3. Remove pad from pad holder.
4. Center new pad on pad driver & secure with
center-lock ring.
Pad driver removal:
1. Apply down pressure on bell of machine deck.
2. Use ¾" open end wrench on top of drive shaft
exposed on top of deck.
3. Strike wrench with rubber mallet to break loose
the shaft from the pad driver. (counter-clockwise)
4. Remove pad driver by spinning it off counter-
clockwise.
LIGHTNING 86039180 05/23/07
MAINTENANCE
4-2
Advertisement
Table of Contents
