Body - Cadillac 1933 V8 Operator's Manual

14
BODY
Invisible Plates
After removing the moulding screws (the invis-
ible screws can be located by running o
screwdriver up a n d down the
glass-run
channel), the garnish moulding can be re-
moved by pulling out at the top and lifting up
if the bayonet type loclt is used or by re/eas
ing the trigger with a screwdriver if the trigger
type is used. See Plates 6 and 7 for loco
Hon and type of fastening.
Screws
Bayonet Lock
Fig. I
Garnish moulding removed to s h o w bayonet
locks and invisible plates.
Spring
Trigger
Fig.
2
Trigger Lock
To unlock, move trigger
in
direct/on indicated by arrow
Rubber rollers should
press lightly against glass
Trim Bow
Regulator Board
•Move roller support
to adjust
pressure of rollers
on glass.
(See Note ) )
Fig. 3
Rubber rollers (or holding front
door glass rigid in open positions.
Adjust screw to increase or de-
crease tension of windshield glass
on weather strip. Both ends of
of regulator board should be ad-
justed evenly to give a weather- ^
proof fit across entire base of
windshield.
Regulator Board
loosen
support
bracket screws
before adjust-
ing regulator
board.
Fig. 4
Adjustment of Windshield Regulator Board
Before adjusting the regulator board, remove the windshield moulding, the sun visor and
the two
screws on
the right-hand end
of the header board. Then loosen the trim, so that
the screws in the support bracket at each end of the regulator board will be accessible.
Plate 4. Door Window Details and Windshield Adjustment