Mounting The Extension Wings; Mounting The Rails And Accu-Fence; Optional Wood Extension Table - Powermatic 64S Operating Instructions And Parts Manual

MOUNTING THE EXTENSION WINGS

Tools required
17mm wrench
straight edge
hammer & wood block (or rubber mallet)
TIP: Use WD-40 to clean the table edges.
1. Have an assistant hold the wing in place while
the three 7/16-14 x 1-1/4 screws are inserted with the
7/16 lock washers. Do not tighten the screws com-
pletely.
NOTE: If an assistant is not available, hold the wing
in a vertical position and insert one 7/16-14 x 1-1/4
screw and one 7/16 lock washer into the middle hole
as shown in Figure 18. Finger tighten this screw to
the saw's table, then pivot the wing to the horizontal
position, and install the other two screws finger tight.
2. The front edge of extension wing is the most criti-
cal and must be flush with the front edge of saw table.
If necessary, tap the edges of the wing using a ham-
mer and a block of wood, or a rubber mallet, until the
front edge of the wing lines up with the front edge of
the table.
4. Clamp a straight edge across both the exten-
sion wing and table top. Level the surface of the wing
with the table top, then tighten the middle screw.
5. Repeat step 4 at the front and back of the exten-
sion wing. Tighten each screw as that part of the wing
comes flush with the table.
6. Repeat the process for the other extension wing.
MOUNTING THE RAILS & FENCE
With the extension wings properly aligned, the rail and
fence assembly can now be mounted to the saw.
Consult the separate fence manual for instructions.

OPTIONAL WOOD EXTENSION TABLE

For instructions on mounting the accessory wood ex-
tension table, or router table, consult the wood exten-
sion table, or router table manual.
14
FIGURE 17
FIGURE 18