Electrical: 230 Volt Conversion - Powermatic 64S Operating Instructions And Parts Manual

ELECTRICAL
230 VOLT CONVERSION
WARNING: The conversion from 115V to
!
230V operation must be done by a
qualified electrician.
The 64S saw is prewired for 115 volt operation. If 230
volt, single phase operation is desired, the following
instructions must be followed:
1. Disconnect the machine from the power source.
2. This saw is supplied with four motor leads that
are connected for 115V operation, as shown in Figure
42. Reconnect these four motor leads for 230V opera-
tion, as shown in Figure 43.
3. The 115V power plug, supplied with the saw, must
be replaced with a UL/CSA listed plug suitable for 230V
operation. (This plug is illustrated in view D in Figure
23). Contact your local Authorized POWERMATIC
Service Center or qualified electrician for proper pro-
cedures to install the plug. The saw must comply with
all local and national codes after the 230V plug is in-
stalled.
4. The saw with a 230V plug should only be con-
nected to an outlet having the same configuration as
illustrated by the grounded outlet box in view D in Fig-
ure 23. No adapter should be used with the 230V plug.
IMPORTANT: In all cases (115 or 230 volts), make
certain the receptacle in question is properly
grounded. If you are not sure, have a qualified
electrician check the receptacle.
26
115 Volt
1 3
RED YELLOW BLACK
LINE
FIGURE 42
230 Volt
1 2 3
RED BLACK YELLOW
LINE
FIGURE 44
2 4
WHITE
LINE
4
WHITE
LINE