Mounting Table Insert; Mounting Extension Wings - Powermatic 64A Instruction Manual

MOUNTING TABLE INSERT

Tools required
3mm hex wrench.
1. Place the table insert in the saw blade opening.
With a straight edge, check to see if the insert is level
with the surface of the table. See Figure 17.
2. If the insert is not level, correct it by using the
straight edge and turning the four 1/4-20 x 5/16 set
screws in or out until the insert is flush with the table.

MOUNTING EXTENSION WINGS

Tools required
17mm wrench
straight edge
hammer & wood block (or rubber mallet)
TIP: Use WD-40 to clean table edges.
1. Have an assistant hold the wing in place while
the three 7/16-14 x 1-1/4 screws are inserted with the
7/16 lock washers. Do not tighten screws completely.
(NOTE: If an assistant is not available, hold the wing
in vertical position and insert one 7/16-14 x 1-1/4 screw
and one 7/16 lock washer into the middle hole. See
Figure 18. Finger tighten this screw to the saw's table,
then pivot the wing to horizontal position, and install
the other two screws finger tight.)
2. The front edge of extension wing is the most criti-
cal and must be flush with the front edge of saw table.
If necessary, tap the edges of the wing with a hammer
and block of wood (or rubber mallet) until the front edge
of wing lines up with edge of table.
4. Clamp a straight edge across both the exten-
sion and table top. Level the surface of the wing with
the table top, then tighten the middle screw.
5. Repeat step 4 at the front and back of the exten-
sion wing. Tighten each screw as that part of the wing
comes flush with the table.
6. Repeat process for other extension wing.
14
FIGURE 17
FIGURE 18