Table of Contents
Advertisement
Using the Program
NOTE: The first time you connect to the Configuration (USB) port, the Found New
Hardware Wizard appears (see figure 11). See "Activating a USB port for the first
time," below.
For other connections, proceed to "Starting the program," below.
1
Figure 11.
Activating a USB port for the first time
The first time you connect to the Configuration (USB) port, the Found New Hardware Wizard
appears (figure 11). Activate the connected USB port for your device as follows:
NOTE: If you have not installed the latest Universal Switcher Control Program
(version 4.1 or newer), click
Reconnect the computer to the Configuration port on the switcher.
6.
Select the
7.
Select the
Follow the on-screen instructions. The wizard assigns the driver necessary to access
the switcher to the connected Configuration (USB) port (this may take a few minutes).
8.
Click
Finish
9.
Proceed to "Starting the program," below, or return to the
Control
NOTE: You may need to repeat these steps if you subsequently connect the
switcher to a different USB port on the same computer.
Starting the program
Start the program as follows:
1.
Connect a computer that runs the Windows
port of the switcher (see
page 7).
2.
Click
Start
Universal Switcher Control Program
The Communication Setup window appears (see
1
Found New Hardware Wizard
Cancel
radio button and click
No, not this time
Install the software automatically
to exit the wizard.
section on page 9.
item
on page 6) or the Configuration port (see
e
>
>
Programs
Extron Electronics
2
, install the program, and reboot the PC.
.
Next
radio button and click
Simple Instruction Set
operating system to either the RS-232
®
>
Universal Switcher
.
figure
12, on the next page).
FOX SW8 • Remote Control
2
.
Next
item
on
a
>
13
Advertisement
Table of Contents
