Accessing The Printer Settings; Working In Test Print Mode; Making A Test Print - Kodak 8800 User Manual

Operating the Printer
Accessing the Printer
Settings
Printer Setting
Printer ready

Making a test print

Checking remaining
media
Checking the printer
total print count
Checking the FEE
firmware version
Checking the DSP
firmware version
Checking the engine
firmware version
Setting the operator
control panel (OCP)
language
Setting the standby
timeout
Setting the level of
matte lamination

Working in Test Print Mode

Making a test print
2-2
Press Menu Scroll repeatedly to scroll through the printer settings in the
following order.
Operator Panel Display Action Required
Ready
Test Print Mode
Remain = XXX/YYY
Printed = XXXXX
FEE Firm X.XX
DSP Firm X.XX
ENG Firm X.XX
Language
Standby Timeout
Matte Level
Make a test print to check that the printer is installed and set up correctly.
Press Menu once until Test Print Mode appears.
1.
Press Enter once until Pattern appears.
2.
Press Enter once to select the test print type.
3.
Press Menu to cycle through the available test print types.
4.
Press Enter to print the selected test print.
5.
When printing is complete, the printer returns to Ready mode.
None. The printer is on and ready to make prints.
Press Enter to enter test print mode. See
print".
None. XXX represents the number of prints remaining out
of the total possible (YYY) for the media currently
installed.
None. XXXXX represents the total number of prints made
since the printer was manufactured. This counter cannot
be reset.
None. The printer FEE firmware version is displayed.
None. The printer DSP firmware version is displayed.
None. The engine firmware version is displayed.
Press Enter.
1.
Select the language.
2.
Press Enter.
1.
Select the standby timeout (Never, 30 minutes, 60
2.
minutes, 120 minutes, 480 minutes).
Press Enter.
1.
Select the level of matte lamination.
2.
(-4, -3, -2, -1, 0, 1, 2, 3, 4)
4J2007
"Making a test
July 2006