Message List - Yamaha RX-V571 Owner's Manual

Message list

Message (alphabetical order)
Access error
CHECK SP WIRES!
Connect error
Loading...
No content
No device
Not found
Unknown iPod
Unable to play
View ON SCREEN
Cause
The unit cannot access your USB storage device or iPod.
There is a problem with the signal path from your USB storage device
to the unit.
The protection circuitry has been activated because this unit was
turned on while a speaker cable was shorted.
There is a problem with the signal path from your iPod to the unit.
The data of the USB storage devices and iPod are being loaded.
There is no playable data on the USB storage devices or iPod.
There is a problem with the signal path from your USB storage device
to the unit.
USB storage device is not connected to the USB port.
The Bluetooth device is not found.
The iPod being used is not supported by the unit.
The unit cannot play back the songs stored on your iPod.
The song that the unit cannot play back is selected, or the selected
song data is damaged.
The selected item cannot be displayed on the front display.
Remedy
Try another USB device or iPod.
Turn off the unit and reconnect your USB storage device to the USB port of the
unit.
When an iPod is connected to the USB port, turn the iPod off and on.
Make sure that all speaker cables between this unit and speakers are
connected properly.
Turn off the unit and reconnect the iPod dock (p.47).
Reconnect the iPod to the iPod dock (p.47).
It takes a long while to load the data when connecting a device that has a
large amount of data.
Connect the USB storage device or iPod in which the playable data are
stored.
Turn off the unit and reconnect your USB storage device to the USB port of the
unit.
When iPod is connected to the USB port, turn the iPod off and on.
Connect the USB storage device to the USB port on the front panel of the unit.
During pairing:
- Pairing must be performed on the Bluetooth device and the unit
simultaneously. Check if the Bluetooth device is in pairing mode.
While connected:
- Check if the Bluetooth device is turned on.
- Check if the Bluetooth device is within 10 m (32 ft.) of the Yamaha Bluetooth
Wireless Audio Receiver.
- Do pairing again.
Connect an iPod that is supported by the unit (p.46).
Check the songs stored on your iPod.
Select and play another song.
Confirm the display on the TV connected with an HDMI cable.
When "SETUP" is displayed at the upper left on the front display, press SETUP
on the remote control to return to normal display on the front display.
When "USB" or "DOCK" at the upper left on the front display, press the cursor
key ( ) to return to the display of menu list or playing song.
86
En