Tuner (Fm/Am); Remote Control - Yamaha RX-V571 Owner's Manual

Problem
The menu of the unit is not displayed.

Tuner (FM/AM)

Problem
FM stereo radio reception is noisy.
AM radio reception is noisy.
Radio stations cannot be selected
automatically.
AM radio stations cannot be preset.

Remote control

Problem
The remote control does not work or
function properly.
External devices cannot be controlled
using the remote control.
Cause
The TV is connected to the unit with a cable except for HDMI cable.
An appropriate video input is not selected on the TV.
Cause
There is multi-path interference.
You are too far from the station transmitter, or the input from the antenna
is weak.
The noises may be caused by lightning, fluorescent lamps, motors,
thermostats, or other electrical equipment.
The signal is weak, or the antenna connections are loose.
Your area is too far from the FM station transmitter.
Automatic station preset is used to preset AM stations.
Cause
Wrong distance.
The batteries are weak.
Direct sunlight or lighting (from an inverter type of fluorescent lamp,
strobe light, etc.) is striking the remote control sensor of the unit.
The operation device is set to an external device.
The remote control ID of the remote control and the unit do not match.
The operation device is set to the unit.
The remote control code is not correctly set.
Remedy
Use an HDMI cable to connect the TV to the unit.
Select the input source of the TV to the video input from the HDMI OUT of the
unit.
Remedy
Adjust the antenna height or orientation, or place it in a different location.
Switch the receiving mode to monaural using MODE (p.42).
Replace the outdoor antenna with a more sensitive multi-element antenna.
It is difficult to completely eliminate noise, but it can be reduced by installing
an outdoor AM antenna.
Adjust the AM antenna orientation.
Replace the outdoor antenna with a more sensitive multi-element antenna.
Select the station manually (p.41).
Use an outdoor antenna commercially available. We recommend using a
sensitive multi-element antenna.
Automatic station preset is not available for AM stations. Use manual station
preset.
Remedy
Operate the remote control within its operating range (p.4).
Replace the batteries (p.4).
Adjust the lighting angle, or reposition the unit.
Switch the operation device to the unit using RECEIVER/SOURCE (it should
glow orange) and operate the unit (p.10).
Match the remote control ID of the unit and the remote control (p.76).
Switch the operation device to the external device using RECEIVER/SOURCE
(it should glow green) and operate the external device (p.10).
Set the remote control code correctly (p.78, 79). Even if the remote control
code is correctly set, there are some devices that do not respond to the
remote control.
85
En