Yamaha RX-V571 Owner's Manual page 74

■
Standby Through
Specify whether or not audio/video signals from HDMI inputs are to continue to be
transmitted to a TV when the unit is in standby mode.
Settings
Off (Default) Does not output HDMI signals to a TV.
On Outputs HDMI signals to a TV (1 to 3 W power consumption)
• When "HDMI Control" is set to "On," "Standby Through" is automatically fixed to "Control Sync" and cannot
be set manually.
• While "Standby Through" is activated, the standby indictor on the front panel lights up.
• While "Standby Through" is activated, the input source can be switched between HDMI1-5 and V-AUX
(HDMI) with the remote control. The standby indicator on the front panel flashes twice in response.
■
Processing
Specifies whether or not to adjust resolution and aspect ratio with the conversion of
video input to HDMI video (upscaling).
Settings
Off (Default) Does not adjust resolution and aspect ratio of video signals.
Adjusts resolution and aspect ratio of video signals. The each
On
parameter can be set in the following "Resolution" and "Aspect."
• Analog video signals can be converted and output to HDMI video despite the setting in this item.
❏ Resolution
Select the resolution of HDMI output video signals. For details on conversion of video
resolution, refer to "Video conversion table" (p.91).
Settings
Through No upscaling.
Auto (Default) Automatic upscaling in accordance with TV resolution.
480p/576p, 720p, Upscaling to the selected resolution. (Only resolutions that the TV
1080i, 1080p supports can be selected.)
■
Procedure
1
Press the cursor keys ( / ) to select a setting.
2
Press ENTER to confirm the selection.
• Only 480i/576i and 480p/576p-resolution video signals can be upscalled (p.91).
• When a resolution that is not supported by the TV needs to be selected, set "MON.CHK" in the
"ADVANCED SETUP" menu to "SKIP" to select the all resolutions (p.77). Please note that selecting the
resolution that the TV does not support may cause a black screen on the TV monitor.
❏ Aspect
Select the aspect ratio of HDMI output video signals.
Settings
Through (Default) Does not adjust the aspect ratio.
Converts 4:3 aspect ratio video signals to a 16:9 TV with black bands on
16:9 Normal
either side of the screen.
74
En