Setting Sound Program And Decoder Parameters (Dsp) - Yamaha RX-V571 Owner's Manual

Setting sound program and decoder parameters (DSP)

Configuring the settings of sound programs and surround decoders.
• Configurable items vary depending on the selected sound program or surround decoder.
■
CINEMA DSP 3D
Turns CINEMA DSP 3D (p.39) on or off. When CINEMA DSP 3D is set to On, the
CINEMA DSP 3D mode automatically turns on in a sound program (except for 2ch
Stereo and 7ch Stereo).
Settings
Off Disables CINEMA DSP 3D.
On (Default) Enables CINEMA DSP 3D.
• This setting can be set when the selected sound program supports CINEMA DSP.
■
Program
Select and adjust a sound program and decoder. Select a sound program of which you
want to change the settings, and then set the parameters for each item. The sound
program is switched at this time.
■
Procedure
1
Press the cursor keys to select "Program" and then press ENTER.
2
Press the cursor keys ( / ) to select a sound program of which you want change
the settings, and then press ENTER.
3
Press the cursor keys ( / ) to select an item of which you want to change the
items, and then press ENTER.
4
Press the cursor keys to adjust the parameters, and then press ENTER.
5
If necessary, repeat step 3 to 4 to set other items.
6
Press SETUP to finish "Program."
• For details on sound program, refer to "Enjoying the desired sound field effect" (p.36).
• Selectable items vary depending on the selected sound program or decoder.
❏ 2ch Stereo
Item Description
Automatically bypasses the DSP
circuit and tone control circuit
Direct depending on the condition of
tone control etc., when an analog
audio source is played back.
❏ 7ch Stereo
Item Description
Adjusts the center channel
Center Level
volume.
Adjusts the volume of the
Surround L Level
surround L channel.
Adjusts the volume of the
Surround R Level
surround R channel.
Adjusts the volume of the
Surround Back Level
surround back channel.
Surround Back L Adjusts the volume of the
Level surround back L channel.
Surround Back R Adjusts the volume of the
Level surround back R channel.
Initializes the level of each
Reset
speaker.
• Selectable items in "7ch Stereo" vary depending on types of speakers connected to the unit.
Setting
Auto (Default), Off
"Auto" outputs sound by bypassing
the DSP circuit and tone control
circuit in the following situations.
• Tone controls of "Bass" and
"Treble" are set to 0 dB (p.60).
• "Equalizer" is set to "Through"
(p.67).
• "Adaptive DRC" is set to "Off"
(p.60).
Setting
0% to 100% (Default: 100%)
0% to 100% (Default: 50%)
0% to 100% (Default: 30%)
OK, CANCEL
Press the cursor keys ( / ) to
select "OK," and then press ENTER
to initialize all level settings.
69
En