Table of Contents
Advertisement
Configuration
(Standalone)
Auto Programs
Program Speed
Custom Mode
Sound-Active
Mode
Adjusting Sound
Sensitivity
Product
Temperature
Page 12 of 18
Set the product in one of the standalone modes to control without a DMX controller.
·
Connect the product to a suitable power outlet.
Never connect a product that is operating in any standalone mode to a DMX string
connected to a DMX controller. Products in standalone mode may transmit DMX
signals that could interfere with the DMX signals from the controller.
To select an auto program, do the following:
1.
Press <MENU> repeatedly until P-- shows on the display.
2.
Press <ENTER>.
3.
Use <UP> or <DOWN> to select P 0–P 7.
4.
Press <ENTER>.
To set the speed for the auto program, follow the instructions below:
1.
Press <MENU> repeatedly until S-- shows on the display.
2.
Press <ENTER>.
3.
Use <UP> or <DOWN> to select S 0–S100, slow to fast.
4.
Press <ENTER>.
To create your own effect in the custom mode, do the following:
1.
Press <MENU> repeatedly until U-- shows on the display.
2.
Press <ENTER>.
3.
Press <ENTER> to select either:
·
d 0–d255 for custom output, 0–100%
·
S 0–S255 for custom strobe speed, slow to fast (0–28 Hz)
4.
Use <UP> or <DOWN> to increase or decrease.
5.
Press <ENTER>.
To enable the Sound-Active mode, follow the instructions below:
1.
Press <MENU repeatedly until Snd shows on the display.
2.
Press <ENTER>.
3.
Use <UP> or <DOWN> to select:
·
Snd1 - cycles through auto programs
·
Snd2 - outward from the center
4.
Press <ENTER>.
To adjust the sensitivity of the Sound-Active mode, do the following:
1.
Press <MENU repeatedly until SenS shows on the display.
2.
Press <ENTER> and u 0-u100 will show on the display.
3.
Turn the music on and adjust the sound sensitivity using the <UP> and <DOWN>
buttons until the product starts responding to the beat of the music.
4.
Press <ENTER>.
To see the current temperature of the Shocker™ 90 IRC, follow the instructions below:
1.
Press <MENU> repeatedly until SET shows on the display.
2.
Press <ENTER> and the current Celsius temperature of the product shows on the
display.
Shocker™ 90 IRC User Manual Rev. 1
Advertisement
Table of Contents
