Table of Contents
Advertisement
Configure templates
6.6 Configure templates
Introduction
Templates are used when the public interfaces gets dynamically assigned IP address.
A template assigns a wildcard (0.0.0.x) to the IP address of the public interface.
Network setup
`
TM
SpeedTouch
PPPoA
192.168.0.1
Public network
101.101.101.x
Wildcard: 0.0.0.1
192.168.0.254
192.168.0.2
GUI
Create a NAT template and fill in the fields.
When a PPP connection is established, the wildcard is replaced by the dynamically
assigned IP address of the PPP interface. Select the Mappings menu.
This is the automatically created NAT map, based on the template. The wildcard is
replaced by the dynamically assigned IP address 101.101.101.47. Any inside
address can use this mapping.
E-NIT-CTC-20040716-0004 v1.0
58
Advertisement
Table of Contents
