Gyro Sense - RadioLink AT9 Instruction Manual

h o v e r . L a n d / s h u t e n g i n e
o f f . A d j u s t t hrottle curves
and rudder trim. Repeat until
model hovers smoothly at
half throttle.Rapidly apply
throttle from 1/4 to 1/2
REVO .
stick. Adjust
points 2 and 3
until the model does not rotate
its nose up on throttle
application.
High point: Adjust
collective pitchcurve to +8
to +10 degrees. From hover,
throttle up rapidly. If
engine bogs,increase the
throttle curve. If engine
over-revs, increase the
collective pitch curve at points
6 or 7. Apply full throttle
while hovering, then descend
back to hover. Adjust REVO .
until the nose does not change
heading.

5.3.3 GYRO SENSE

About GYRO SENSE, please refer to 3.3.12, by following steps:
Goals
Set up heading-
hold /AVCS gyro
with
heading-hold/AVC
S setting in
idle-ups 1 and 2
and normal mode
setting in idle- up3
and normal.
Adjust
PIT-CURV/NOR
Adjust REVO.MIX
Adjust
THR-CURV/NOR
Adjust
PIT-CURV/NOR
Adjust REVO.MIX
Steps
Open and activate the GYRO
SENSE function.
Activate the function.
Optional: Change gyro types to
Heading- hold ( GY ).
Optional: Changes switch
Ex: select Cond .
assignment.
Adjust gyro rates as needed.
(Ex: NORM , IDL3 to NOR 50% .
IDL1 and 2 to AVC 50% as starting
points.)
Repeat above as needed
Repeat above as needed
Repeat above as needed
Repeat above as needed
Repeat above as needed
Inputs
for 1s to BASIC.(If ADVANCE
again) .
to GYRO-SENSE
to MIX
to MODE
to SW
，
to NORM,
to IDL1
Repeat.
68
to ACT.
，
to GY
，
to Cond
to NOR 50%
，
to AVC 50%
，